- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello
I have additional questions about this thread.
It would be very helpful if you could answer by 5/10.
There was a reply that you should develop using the latest version, but how should I migrate?
An error occurs when trying to open a .soc file created with Ver4.4 with Ver5.4.
Can it be solved on the assumption that the file created with Ver4.4 is used?
Best Regards
Hayto
Solved! Go to Solution.
- Labels:
-
PSoC1 MCU
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You can open the PSoC Designer 4.4 project using PSoC Designer 5.0, and rebuild the same. After successfully rebuilding the project using PSoC Designer 5.0, you can migrate the project to PSoC Designer 5.4, and rebuild.
Best regards,
Sampath Selvaraj
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You can open the PSoC Designer 4.4 project using PSoC Designer 5.0, and rebuild the same. After successfully rebuilding the project using PSoC Designer 5.0, you can migrate the project to PSoC Designer 5.4, and rebuild.
Best regards,
Sampath Selvaraj