Feb 16, 2022
09:54 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 16, 2022
09:54 AM
I wrote a blog post on programming the KitProg finger stub board on the CY8CKit-059. I chopped a USB Extender cable and use one additional 30 gauge wire to allow for the reset, and was able to load arbitrary code into the finger stub's PSOC5LP.
I also covered using fw-loader to upgrade the firmware on KitProg2 and KitProg3.
The article is here: https://socmaker.com/?p=1108
Solved! Go to Solution.
Labels
- Labels:
-
ispn:39618:1:0
-
l1:314:1:0
1 Solution
Feb 21, 2022
03:46 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 21, 2022
03:46 AM
2 Replies
Feb 17, 2022
08:34 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 17, 2022
08:34 AM
WaMa,
Thank you for your contribution and your work!
Suggestion: Place a link to this thread in "Code Examples". "Code Examples" was intended to be a place to share 'solutions'.
Len
"Engineering is an Art. The Art of Compromise."
"Engineering is an Art. The Art of Compromise."
Feb 21, 2022
03:46 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Feb 21, 2022
03:46 AM