- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Labels:
-
PSoC 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Which device are you using? See following KB article on PSoC devices supported by ICE4000 -
http://www.cypress.com/?id=4&rID=45620
You may have to install PSoC programmer v2.33. See below KB article -
http://www.cypress.com/?id=4&rID=34495
It is not possible to program in PD4.2 with a hex file generated by some other project; in this case, PD5.3 project.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I'm using CY8C27443.
I studied the problem and believed that the structure of hex-file should not in principle depend on the version of the program in which the file was created. The structure should be unified, is not it?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I also think so. Hex file format should not change. But I am not 100% sure.
However, the main issue here is not the designer version but the programmer software version.You should have v2.33 to talk to ICE4000.