Jul 08, 2021
01:28 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 08, 2021
01:28 AM
Good luck !
My chip is C Y P D 3174-24 pin with Mini P r o g 3 Programmer.
Before programming,Target Power(red)is lighting,and Status(green)is twinkling.
When programming,red light is twinkling either.
then it turns to failed.
What's more, what should we do when using Cypress Programmer , to connect P SOC and PC and make computer recognize the device, as was shown in Page 11, Cypress Programmer GUI User Guide ?
Solved! Go to Solution.
Labels
- Labels:
-
PSoC3 MCU
1 Solution
Jul 08, 2021
07:30 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 08, 2021
07:30 PM
Already done. The data and the clk wire was connected in a wrong way.
1 Reply
Jul 08, 2021
07:30 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 08, 2021
07:30 PM
Already done. The data and the clk wire was connected in a wrong way.