Anonymous
Not applicable
Jul 12, 2013
04:15 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 12, 2013
04:15 PM
I have dynamixel motor (http://www.electronickits.com/robot/BioloidAX-12(english).pdf) and CM900 kit. I want to drive dynamixel motor with psoc3. There is ttl communication on the cm900 kit. Maybe I can communicate psoc3 but I do not know how to write a c code. How can I do that?
Labels
- Labels:
-
PSoC 3
2 Replies
Anonymous
Not applicable
Jul 12, 2013
04:57 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 12, 2013
04:57 PM
HI I'm looking through the PDF. Communication that will do by Half duplex UART with TTL level interface.. So you have to use the UART module and connect directly. Regarding software, you submit instruction packet and will get status packet from the motor. There are sample program list in there, you can use it to meets psoc program code. It is not hard, I guess so. Thank you.
Attachments are accessible only for community members.
Jul 13, 2013
08:40 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 13, 2013
08:40 PM