- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi.
Is it possible for the bootloader project to have a different layout (i.e. using different components in TopDesign) than the bootloadable project?
For example: the bootloader has a UART connected to pins X and Y, and the bootloadable uses the same pins for different purpose.
Thanks.
Solved! Go to Solution.
- Labels:
-
PSoC 5LP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
"Kind of". Not only the UDBs get reconfigured, but the complete hardware layout as clocks, wires, components, system settings etc.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Yes, that is quite possible. Keep in mind that switching from bootloader to the bootloadable project works with an internal reset. Thus the hardware gets initialized with all the new components of the bootloadable.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
PSoC UDBs are kind of FPGA, right? After each reset the hardware layout is reloaded?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
"Kind of". Not only the UDBs get reconfigured, but the complete hardware layout as clocks, wires, components, system settings etc.
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you