- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I have 2 PSOC5LP DVKs with 10 pin JTAG headers on each. I have wired them into a bread board connecting them via JTAG daisy chain schematic using the TDO of one DVK into the other DVK's TDI. I cannot get them appear in Psoc Programmer. I clicked the JTAG tab and 'Scan bus' and nothing happens, it says it detected 100 devices but that obviously is wrong. If there are any guides or how-tos on this is done that would be great. I will unhook everything and retry in the meantime.
Solved! Go to Solution.
- Labels:
-
PSoC 5 Device Programming
-
PSoC 5LP
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Yes you can find guides inside PSoC Programmer > Help > Help Topics. Then, search for the topic "JTAG Programming Protocol" which provides detailed explaination about the connections and how to get them to work.
Regards,
Dheeraj
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Yes you can find guides inside PSoC Programmer > Help > Help Topics. Then, search for the topic "JTAG Programming Protocol" which provides detailed explaination about the connections and how to get them to work.
Regards,
Dheeraj