Anonymous
Not applicable
Oct 10, 2009
05:26 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 10, 2009
05:26 PM
Are there any known issues with pins no longer working for capsense after being used for digital I/O? I have the PSoC Development kit and accidently assigned a digital I/O function to P0.5 and then corrected the assignment back to capsense function...the capsense function for that port no longer functions...I can reassign it to another pin and the functionality works...if I assign back to P0.5 it will not work...I assigned P0.5 for digital functions and it works fine for digital I/O...Any suggestions/workarounds?
Labels
- Labels:
-
PSoC 5LP
2 Replies
Anonymous
Not applicable
Oct 26, 2009
10:11 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Oct 26, 2009
10:11 AM
Smuraski,
Is their any chance that you have P0[5] wired to something on the development kit's breadboard? You should have no issues assigning a CapSense pin with a different functionality, and then later setting it back.
Regards,
Bobby
Is their any chance that you have P0[5] wired to something on the development kit's breadboard? You should have no issues assigning a CapSense pin with a different functionality, and then later setting it back.
Regards,
Bobby
Anonymous
Not applicable
Aug 26, 2010
01:34 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Aug 26, 2010
01:34 AM
Hi,
You can try like this: First make the pin properties as default in pin properties window. and then reassign the pin to capsense into the capsense wizard. then I Think it should work.
regards,
Sheshmal