Anonymous
Not applicable
Jul 22, 2016
09:02 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jul 22, 2016
09:02 AM
Hello,
I use the device Cy8C4013LQI.
I must disable all components for power saving.
So I followed the instruction to change the debug interface to from SWD to GPIO.
Programming should always be possible.
But after download the firmware I can not connect the device anymore.
I use Segger-Jlink with the newest Firmware and software.
Here I found a similar problem.
http://forum.segger.com/index.php?page=Thread&threadID=2945
There are speaking about the version p, but in the download area only available version j.
So - how can I fix the problem? Now I blocked 3 prototypes.
2 Replies