- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
hello everyone
I use cy8c4014sxi-421 IC, which program using miniprog3 ,some of ic program easily and some of ic show hex didn't match, all ic same and all ic from 1 reel and same production date. here I attached image .
Solved! Go to Solution.
- Labels:
-
PSoC 4 MCU
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @pasa_1340461 ,
The MBR range of devices cannot be programmed but only be configured for a specific operation using an interface for example like I2C. So PSoC Programmer cannot program these devices with a hex file.
I would suggest you contact your supplier for a replacement for these chips.
Warm Regards
Alen
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @pasa_1340461 ,
Can you please share an image of the markings on those IC's which do fail when you try to program using PSoC Programmer?
Is it also possible for you to share the hex file you are trying to program the ICs with us as well?
Regards
Alen
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
You can archive it as a zip file and share the same.
Regards
Alen
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @pasa_1340461 ,
For the device that the failure occurs, from the image you have shared of PSoC Programmer, it seems that the device ID that is auto-detected / read from the device is not CY8C4014SXI-421 as shown below
This is why the programmer reports a mismatch between the hex file and the device as hex file is generated for CY8C4014SXI-421 device.
1. Can you please let us know the source or from where you have purchased the devices?
2. Are you able to perform an erase operation on the device which reports this error from PSoC Programmer?
Warm Regards
Alen
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @pasa_1340461 ,
The MBR range of devices cannot be programmed but only be configured for a specific operation using an interface for example like I2C. So PSoC Programmer cannot program these devices with a hex file.
I would suggest you contact your supplier for a replacement for these chips.
Warm Regards
Alen