- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
It should be part of the Creator install (or maybe PSoC Programmer).
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I already install anything (complete installation) with DVD ISO.
I can use CY8CKIT-042-BLE-A Bluetooth® Low Energy 4.2 Compliant Pioneer Kit as before with the installation.
So it is very strange....
Is there a way to restore KitProg of the board? I think that the KitProg maybe corrupt....
After restoring KitProg, it still no driver associates with KitProg...
I notice that my another computer(WIN10 64Bit) can detect driver and install, how to fix in WIN7 64Bit?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Try to update the Kitprog as shown in the manual using PSoC Programmer 3.25
Bob
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,Bob
I already restore KitProg many times by using PSoC Programmer 3.25..., the result is the same.
Computer1(WIN7 64Bit)
CY8CKIT-042-BLE...OK
CY8CKIT-046...Not OK
Computer2(WIN10 64Bit)
CY8CKIT-042-BLE...OK
CY8CKIT-046...OK
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hold down the Reset button for 10 Sec and see if that helps.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Drivers for Kit prog are in the kit prog dir.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi, I already restore KitProg of the board and reinstall the driver many times...
But ONLY the CY8CKIT-042 Kit can be properly detected and installed driver.
CY8CKIT-046 is still not working...
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I reinstall PSOC Creator 3.3 and 4.0, WIN7 machine doesn't show any errors and problems.
By the way, CY8CKIT-046 Mouse Demo (J11 USB Port) is also no driver to use, but WIN10 machine can properly install driver to use.
WIN7-CY8CKIT-042
.
WIN7-CY8CKIT-046
WIN7-CY8CKIT-046-DEMO
WIN10-CY8CKIT-042
WIN10-CY8CKIT-046
Thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Solve problem by upgrading WIN7 with Original DVD.