- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Where can I find the specification for the total allowable device current for the PSoc 4 BLE (CY8C4248LQI-BL583)?
I looked in the datasheet, expecting to find it under "Device Level specifications".
There is a 25 mA spec for max GPIO current per pin, but nothing specifies how much total current the device can source or sink from all GPIO pins simultaneously.
I also looked in the TRM, but couldn't find it there either.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello.
You were close to finding it, just needed to look at little further down the datasheet.
It's listed at bottom of GPIO DC Specifications.
200mA.
Regards.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello.
You were close to finding it, just needed to look at little further down the datasheet.
It's listed at bottom of GPIO DC Specifications.
200mA.
Regards.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Thank you. Guess I went datasheet-blind for a bit. I knew it had to be in there.