Anonymous
Not applicable
Dec 06, 2013
09:07 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 06, 2013
09:07 PM
I have 3 of these, when they are powered up the status led flashes and it shows up as an HID in device manager, when I program it with kitprog.hex the flashing stops until power is removed and the device is the powered up again, once that's done it does the flashing again. Thoughts suggestions. HELP!!!!!!!!!!!!!!!!!!!!!!!!!
4 Replies
Anonymous
Not applicable
Dec 06, 2013
09:41 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 06, 2013
09:41 PM
Did you said about Pioneer-Kit
What is your problem? come again
What is your problem? come again
Dec 07, 2013
12:10 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 07, 2013
12:10 AM
Afak this is the normal behaveour, the "Kitprog" is a test-program that does flash the LED. What do you think does n ot work? What do you expect to happen?
Bob
Dec 07, 2013
06:08 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 07, 2013
06:08 AM
Anonymous
Not applicable
Dec 22, 2013
02:59 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 22, 2013
02:59 PM
Looks like #1 in the table explains it, thanx all!