- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello All,
I'm working with capsense buttons example code provided with CY8CKIT - 046 KIT.
I'm trying to integrate UART in interrupt mode, and it's not working. It seems system goes in sleep mode and hence it's not working.
Can someone please shed some light, what's going on?
Solved! Go to Solution.
- Labels:
-
PSoC 4 Architecture
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Ashish,
You seem to not have not checked "Rx FIFO not empty" in UART SCB component configurator window. (UART Advanced tab)
Pls enable the "Rx FIFO not empty" interrupt source and check if ISR is triggered.
Thanks,
Shanmathi
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Pls let us know which code example you are using or you could also attach your project.
Also, elaborate on your issue so that we can reproduce it at our end.
Thanks,
Shanmathi
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Ashish,
You seem to not have not checked "Rx FIFO not empty" in UART SCB component configurator window. (UART Advanced tab)
Pls enable the "Rx FIFO not empty" interrupt source and check if ISR is triggered.
Thanks,
Shanmathi