- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I need to build an application using CYBLE-012011 module configured as observer.
Once thee module detects certain advertising data, it has to configure itself as Beacon fot a certain time.
Is there any software example for this?
Thanks,
Alfonso
Solved! Go to Solution.
- Labels:
-
BLE
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
If you put the device into Deepsleep during advertisement state(or connection state) then the BLESS interrupt will wakes up the system from DeepSleep for every advertisement interval or connection interval. In your project, when you stop advertising then after entering into the low power mode device is not waking up to restart the advertisement. So, you can use a WDT timer for waking up the device and restart advertising.
Thanks,
P Yugandhar.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Alfonso,
You can refer the following project from github which is a perfect example for your requirement. Kindly go through this and let us know if you have any queries.
You can also go through Day08 Constant broadcaster and Day010 Observer from the link below:
PSoC-4-BLE/100_Projects_in_100_Days at master · cypresssemiconductorco/PSoC-4-BLE · GitHub
Thanks
Ganesh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Ganesh,
Thanks for Your suggestions
I'm trying to create step by step my own application that should Broadcast i-Beacon Data (with modificable Payload) and scan for external I-Beacons
At the moment I'm trying unsuccessfully to start and Stop Advertisments,
I can stop them but not restart and I can't understand where I'm wrong.
I Attach my Project, can you please Help?
Thanks,
Alfonso.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
If you put the device into Deepsleep during advertisement state(or connection state) then the BLESS interrupt will wakes up the system from DeepSleep for every advertisement interval or connection interval. In your project, when you stop advertising then after entering into the low power mode device is not waking up to restart the advertisement. So, you can use a WDT timer for waking up the device and restart advertising.
Thanks,
P Yugandhar.