Anonymous
Not applicable
Sep 22, 2016
09:16 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 22, 2016
09:16 PM
Hello,
I want to use a PRoC based hardware for advertising slave ID & some 10 byes custom data from the save device to the central receiver / Phone. These slave devices will be in non-connectable advertise mode & go to sleep immediately after sending their packet
They will wake up every 10 sec on low freq crystal & send the packet again
most of the example codes that are provided do not have a non-connectable broadcast configuration
Can you let me know if there is an example code for PRoC / PSoC which i can use.
Regards,
Mandar Gadgil
Labels
- Labels:
-
BLE
1 Reply
Sep 23, 2016
03:20 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 23, 2016
03:20 AM
Hi Mandar Gadgil,
Please go through our Dynamic broadcaster example. I hope it will be suitable for you application.
Thanks,
Anjana