Mar 06, 2021
03:56 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 06, 2021
03:56 AM
Hi All
I found the NAK Signal During the write frame.
I have attached the logic analyzer observation result for the same.
Master Device:- PIC Controller
Slave Device :- Cy8C4025AZI-S413
My Slave Address is 0x08
Ideally After Address byte their should be ACK From Slave but I observed NAK Signal.
I am not getting where is the exact mistake?
Any help will be highly appreciated.
Regards,
AsDh
Labels
1 Reply
Mar 08, 2021
03:16 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Mar 08, 2021
03:16 AM
Duplicate thread. Moving discussions to https://community.cypress.com/t5/PSoC-4-MCU/I2C-Communication-Issue-Between-Two-Controller/td-p/2691...
Regards,
Bragadeesh
Bragadeesh