- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I have a CY8CKIT-041-40XX kit and I want to use the on-board Kitprog2 to program an external Psoc4 chip.
I read Kitprog2 user manual on section 5.2.
It says possible but need to remove zero-ohm resistors to disconnect the onboard chip.
So I read CY8CKIT-041-40XX Kit Guide but I can't find out which zero-ohm should be removed.
My question is how to do it on CY8CKIT-041-40XX kit.
Thanks.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
You should be able program another device even without removing the 0 ohm resistor as there are resistors in SWDIO and SWDCLK lines.
Kit schematic is available at <install_directory>\CY8CKIT-041-40XX PSoC 4 S-Series Pioneer Kit\\Hardware\CY8CKIT-041-40XX Schematic.pdf ■ <install_directory>\CY8CKIT-041-40XX PSoC 4 S-S
In that R32 is the resistor you are searching for
Best Regards,
VSRS
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi vsrs,
Thanks for your response.
Do you mean that just connect external chip through J10? No resistor need to be unsolder.
Thanks.