- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am using PSoC 4 MCU "CY8C4247AZI-M485", Now when i try to program my MCU with miniprog3's 5 Pin connector, it gives me an error saying this. " Detected SiliconID: "FF FF 13 A1" is not in database ", Please help me in resoving this issue.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Chandresh,
Could you please make sure all the power connections are proper. Please use the following document http://www.cypress.com/file/141176/download power supply section. Normally this will happen when connection to VCCD pin is not properly given. The voltage to that pins should be between 1.71-1.89V.
Best Regards,
VSRS
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Chandresh,
Could you please make sure all the power connections are proper. Please use the following document http://www.cypress.com/file/141176/download power supply section. Normally this will happen when connection to VCCD pin is not properly given. The voltage to that pins should be between 1.71-1.89V.
Best Regards,
VSRS