Announcements

Help us improve the Power & Sensing Selection Guide. Share feedback

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
NIFR_4499596
Level 2
Level 2
Welcome! 5 replies posted First question asked

Hi All,

I have a big problem in my PCB project, I need to use 2 SCB components (SPI and I2C) but I make a mistake in choosing their pins and I can only access SPI or I2C in separate projects. The pins I choose are the following and I found out only now I mixed SCB0 and SCB1 pin for SPI and I2C. I would like to know if it exists a solution to solve the problem without soldering two flying wires on different pins as 3.4 3.5 or 5.0 5.1.

pastedImage_0.png

Thank's for all who wants to give an advice.

Francesco

0 Likes
1 Solution
Alakananda_BG
Moderator
Moderator
Moderator
50 likes received 250 sign-ins 250 replies posted

Hi Francesco,

Since this module does not have UDB components, you have to connect to wires externally.

Regards

Alakananda

Alakananda

View solution in original post

0 Likes
1 Reply
Alakananda_BG
Moderator
Moderator
Moderator
50 likes received 250 sign-ins 250 replies posted

Hi Francesco,

Since this module does not have UDB components, you have to connect to wires externally.

Regards

Alakananda

Alakananda
0 Likes