- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I would like to use the CY8CKIT-149PSOC prototyping kit to test my slider design. The idea is to separate the original slider part from the kit. Then I solde 2,54mm pin header connector female on processor part of the kit, and a 2,54mm male connector on my slider board. Then I can connect them, provided that the pinout of my slider board is compatible with the processor part of the kit.
The kit is designed with a snap-away form-factor, so the separation should be possible without damage.
Do you think it is possible?
Solved! Go to Solution.
- Labels:
-
ispn:40045:1:0
-
l1:314:1:0
-
PSoC4MCU
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @GeFLo
Yes, this is possible. The only thing to keep in mind is to set the right pin assignments and it will work as usual.
Best regards,
Hari
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi @GeFLo
Yes, this is possible. The only thing to keep in mind is to set the right pin assignments and it will work as usual.
Best regards,
Hari