hi,
Am currently working on DPS310 pressure sensor, am getting my pressure values around 95000(atmospheric pressure) ,but i have a doubt regarding,
while am taking pressure readings every time the Base value(95000) is changing,could i know what is the reason and i have seen soldering drift effects a maximum of 0.8hpa (80 pascals) is that the reason or what could be the reason ??
1.I am unable to found AN487 DATASHEET which is shown in page no:- 6 in Dps310 datasheet if possible provide me with that AN487 datasheet
2.I have set my temperature and pressure configuration as follows
Temperature Measurement rate=128mr/sec
Temperature Oversampling=2 times
Pressure Measurement rate=128mr/sec
Pressure Oversampling=single(low precision)
Plz provide me with a solution
thanks in advance
suraj.n
