- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
I am working with a CYTMA525C driver and I have one question.
How can I put the touch panel in low power mode? I guess that It’s activating LOW_POWER_EN, but I tried and don’t work.
I send this array by I2C:{0x04, 0x00, 0x08,0x00,0x2F,0x00,0x06,0x06,0x01,0x01} following the tables of datasheet.
Solved! Go to Solution.
- Labels:
-
Community Information
-
Help
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am afraid this community does not have the expertise on this chip. You may try Paradetech or the place where you got the setup for help.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
CYTMA525 was devested from Cypress(Infineon now) to Paradetech, recommend you to contact Paradetech at https://www.paradetech.com/ for help.
Thanks,
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
My need is to lower the current consumption in low power moed. Now, with default configuration, I have a consumption of 150uA, and I see current peaks at 50ms intervals.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I am afraid this community does not have the expertise on this chip. You may try Paradetech or the place where you got the setup for help.