- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
For Writing into the multiple memory locations in an loop
iam giving commands
write enable 50---> write command 01 in which i'am writing into STR 1 ,cfgr1,2,3,4---->in for loop{ write memory (02) followed by starting address and data }
Is this sequence correct? i'am able to write only at one memory location after that if is not accepting when iam trying to read i got to Know it is not programmed , only starting memory location is programmed.
what is the issue ? despite of giving enough latencies after each write still its not taking
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Shraddha,
For S25HL512T does not support write command 01.
Please refer the Write any register transaction of page 56/141 of the data sheet.
Please register SEMPER Secure Solution program by following link: https://www.infineon.com/cms/en/product/promopages/semper-solutions-hub/
Where you will get SDK (Semper Development Kit).
Can you please share your program code and logic analysis traces of the operation you are performing.
Regards,
Yuvraj
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Shraddha,
Thank you for contacting Infineon Technologies.
Can you please provide the waveform of the operation?
Regards,
Yuvraj
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Shraddha,
For S25HL512T does not support write command 01.
Please refer the Write any register transaction of page 56/141 of the data sheet.
Please register SEMPER Secure Solution program by following link: https://www.infineon.com/cms/en/product/promopages/semper-solutions-hub/
Where you will get SDK (Semper Development Kit).
Can you please share your program code and logic analysis traces of the operation you are performing.
Regards,
Yuvraj