- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
In Table 11.9 ASO Entry Timing of the data sheet, there is the following note.
If this timing cannot be achieved, perform the following steps immediately after ASO Exit and before resuming normal processing: read one word from each of 64 unique 32 byte-aligned pages.
If you have a sample source for this procedure, would you please share it?
Thanks,
Tetsuo
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Tetsuo,
Thank you for contacting Infineon Technology Company.
Here is a simple example code for the procedure:
byte_address=0;
For (i=0;i++;i<64)
{
read one word at byte_address;
byte_address += 32;
}
Please note, only if ASO Entry Timing (25 ns < tASOENTRY < 50 ns or tASOENTRY > 150 ns) can not be achieved, this procedure is needed following ASO Exit command.
Thank you
Regards,
Bushra
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Tetsuo,
Thank you for contacting Infineon Technology Company.
Here is a simple example code for the procedure:
byte_address=0;
For (i=0;i++;i<64)
{
read one word at byte_address;
byte_address += 32;
}
Please note, only if ASO Entry Timing (25 ns < tASOENTRY < 50 ns or tASOENTRY > 150 ns) can not be achieved, this procedure is needed following ASO Exit command.
Thank you
Regards,
Bushra