Dec 27, 2022
01:48 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 27, 2022
01:48 AM
When resetting the slew rate on the IS pin, I understand that Feedback Temperature is set in SR Selection Mode, and after Current SR Feedback, INH = 1 when the specified SR level is reached. For example, if the SR level is SR4 in Current SR Feedback, does it start from SR5 next or from SR0?
Solved! Go to Solution.
Labels
- Tags:
- slew rate
1 Solution
Dec 29, 2022
07:02 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 29, 2022
07:02 PM
You can refer this Typical_application_waveform 2.5 Slew rate selection mode
We can see that the mode starts at in current SR mode.
1 Reply
Dec 29, 2022
07:02 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 29, 2022
07:02 PM
You can refer this Typical_application_waveform 2.5 Slew rate selection mode
We can see that the mode starts at in current SR mode.