- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Is there a way to write an application hex(Modus Toolbox app) file to target board by command line?
Solved! Go to Solution.
- Labels:
-
ModusToolbox General
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello
- Execute the bat file below.
<path_to_the_ModusToolbox>/ModusToolbox/tools_2.4/modus-shell/Cygwin.bat
- Execute the command below.
<path_to_the_ModusToolbox>/ModusToolbox/tools_2.4/openocd/bin/openocd -s <path_to_the_ModusToolbox>/ModusToolbox/tools_2.4/openocd/scripts -c "source [find interface/kitprog3.cfg]; ; source [find target/psoc6_2m.cfg]; psoc6 allow_efuse_program off; psoc6 sflash_restrictions 1;<application path/application name>.hex verify reset exit;"
Thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello
- Execute the bat file below.
<path_to_the_ModusToolbox>/ModusToolbox/tools_2.4/modus-shell/Cygwin.bat
- Execute the command below.
<path_to_the_ModusToolbox>/ModusToolbox/tools_2.4/openocd/bin/openocd -s <path_to_the_ModusToolbox>/ModusToolbox/tools_2.4/openocd/scripts -c "source [find interface/kitprog3.cfg]; ; source [find target/psoc6_2m.cfg]; psoc6 allow_efuse_program off; psoc6 sflash_restrictions 1;<application path/application name>.hex verify reset exit;"
Thanks