Re: BLDC Motordriver BLDC-SHIELD-TLE-9879-TOBO1

Announcements

Webinar: Integrated solutions for smaller, simpler low-voltage motor control design.
Join the webinar to experience!

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
SamarpitKarar
Level 1
Level 1
First question asked First reply posted Welcome!

Hello,

Please guide us how to make the connections (3 Hall sensor wires - Blue, White, Green) of the motor(DB59M024035-A) with Arduino Uno through the motor shield (Infineon BLDC shield with TLE9879QXA40).

Regards

0 Likes
1 Solution
Sahil_K
Moderator
Moderator
Moderator
250 replies posted First like given 100 solutions authored

Hi @SamarpitKarar ,

You can try changing the hall sensor cables( BLUE(H1),GREEN(H2), WHITE(H3)) with respect to the phase excitation, You will be able to change this by interchanging any two hall sensor outputs  H2-> H3 or H3->H1 or H1->H2 ) and then try starting the motor by start command.

 

Note: Sometimes HALL input requires an external Pullup.

 

Please let us know if you have further queries.

Thank you

Best Regards

Sahil Kumar

 

View solution in original post

0 Likes
2 Replies
Sahil_K
Moderator
Moderator
Moderator
250 replies posted First like given 100 solutions authored

Hi @SamarpitKarar ,

You can try changing the hall sensor cables( BLUE(H1),GREEN(H2), WHITE(H3)) with respect to the phase excitation, You will be able to change this by interchanging any two hall sensor outputs  H2-> H3 or H3->H1 or H1->H2 ) and then try starting the motor by start command.

 

Note: Sometimes HALL input requires an external Pullup.

 

Please let us know if you have further queries.

Thank you

Best Regards

Sahil Kumar

 

0 Likes
Sahil_K
Moderator
Moderator
Moderator
250 replies posted First like given 100 solutions authored

Hi @SamarpitKarar ,

Please let us know if your current issue is resolved and have any further queries.

Thank you

Best Regards

Sahil Kumar

0 Likes