cancel
Showing results for 
Search instead for 
Did you mean: 

MOTIX™ Bridges

User22227
New Contributor
Hi,

This is Chamarthi from India. I am using the BLDC Shield IFC007T board for controlling the BLDC motor. While developing the current controller, I observed there is an
offset existing in the IS pin for zero current. We want to know the method to compensate the OFFSET in the signal IS of the board. Please share with us if there is any
possible compensation method in the control algorithm, which would be easy and handy for us.

with regards,
Chamathi.
0 Likes
4 Replies
User22227
New Contributor
Is there anyone who knows the way to remove the offset error in the application code?

please share the information
0 Likes
Markus_M_
Employee
Hi,
you are right, the IS current consist of an offset and the sense current information.
The offset correction isn't implemented.
You may want to measure the offset via the ADC before you run the software and substract this value later on.
You may also check on github:
https://github.com/Infineon/IFX007T-Motor-Control

MMA
0 Likes
User22227
New Contributor
Thanks for the reply Markus

I am doing experiments in resolving this issue, if I know I can share you.
0 Likes
Markus_M_
Employee
Hi Sivaram,
would be great to share your experience in the forum.
Best regards
Markus
0 Likes