- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello all,
I am trying to setup a simulation with the Spice model of the SiC MOSFET IMZA120R020M1H_L3 provided.
After running the simulation I get an Spice Error Log in LTSpice (see attachement)
The simulation itself is a standrad double pulse test, a screenshot is also attached.
I think there may be something wrong with the model itself because this simulation setup works fine with other SiC transistors from Wolfspeed.
I hope you can help me fix the model/simulation.
Thank you and kind regards
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Yes, you can use the model to get the desired results. we will try to rectify the errors at our end.
Regards,
Rishabh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Good day!
If you can share me simulation model, I will try to mimic it from my end.
Regards,
Rishabh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
any update?
Thank you and kind regards
Vin
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
The simulation is not stopping midway, I am getting the results. may be due to some issue in the SUBCKT model of MOSFET we are getting a popup after completing the simulation time.
Regards,
Rishabh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
thank you for looking into it.
Does that mean I can use the model and ignore the Spice Error? Are you guys planning to fix the problem in the model so that the error doesn't pop up?
Kind regards
Vin
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi,
Yes, you can use the model to get the desired results. we will try to rectify the errors at our end.
Regards,
Rishabh
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Ok, thank you very much for your help!
Kind regards
Vin