Inverter circuit discuss

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
KUOWENYUNG
Level 3
Level 3
25 replies posted 100 sign-ins 50 sign-ins

Dear Sir,

I have inverter design refer the following web link.

May I know the SPW20N60C3 is best design for hard switch full bridge? as I know, the topology is no needs fast recovery type, so we just concern short circuit test, am I right?

https://www.ti.com/tool/TIDM-SOLAR-ONEPHINV?keyMatch=TIDR753

 

Kind regards,

 

Kuo

0 Likes
1 Solution
sushank
Moderator
Moderator
Moderator
25 solutions authored 100 sign-ins 50 replies posted

hello there, 

thanks for the posting the question in infineon community 

SPW20N60C3 can be used in the application where there is hard switching but what  you need to take care of is that the total loss within the mosfet junction should not be cause temperature to go beyond the 150degC. 

if this happens than you have to increase the mosfet rating and recheck again. 

thanks. 

View solution in original post

0 Likes
2 Replies
sushank
Moderator
Moderator
Moderator
25 solutions authored 100 sign-ins 50 replies posted

hello there, 

thanks for the posting the question in infineon community 

SPW20N60C3 can be used in the application where there is hard switching but what  you need to take care of is that the total loss within the mosfet junction should not be cause temperature to go beyond the 150degC. 

if this happens than you have to increase the mosfet rating and recheck again. 

thanks. 

0 Likes
sushank
Moderator
Moderator
Moderator
25 solutions authored 100 sign-ins 50 replies posted

Hi there 

due to no further questions we are locking this thread

thanks again for using the infineon community.

0 Likes