- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dear Sir,
I have inverter design refer the following web link.
May I know the SPW20N60C3 is best design for hard switch full bridge? as I know, the topology is no needs fast recovery type, so we just concern short circuit test, am I right?
https://www.ti.com/tool/TIDM-SOLAR-ONEPHINV?keyMatch=TIDR753
Kind regards,
Kuo
Solved! Go to Solution.
- Labels:
-
ispn:4870:1:0
-
l1:144:1:0
-
l2:152:1:0
-
l3:1341:1:0
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
hello there,
thanks for the posting the question in infineon community
SPW20N60C3 can be used in the application where there is hard switching but what you need to take care of is that the total loss within the mosfet junction should not be cause temperature to go beyond the 150degC.
if this happens than you have to increase the mosfet rating and recheck again.
thanks.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
hello there,
thanks for the posting the question in infineon community
SPW20N60C3 can be used in the application where there is hard switching but what you need to take care of is that the total loss within the mosfet junction should not be cause temperature to go beyond the 150degC.
if this happens than you have to increase the mosfet rating and recheck again.
thanks.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi there
due to no further questions we are locking this thread
thanks again for using the infineon community.