Dec 15, 2022
04:43 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 15, 2022
04:43 PM
Hi,
In IMZ120R060M1H datasheet, pin 2 & 3 are connected together.
In application, how to connect these two pins in the layout? Can tie these two pins together?
Solved! Go to Solution.
Labels
1 Solution
Dec 15, 2022
07:58 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 15, 2022
07:58 PM
3 Replies
Dec 15, 2022
06:40 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 15, 2022
06:40 PM
Thanks for your comments.
The SiC MOSFET had set KELVIN connect for best. 2Pin is power source pin, 3Pin is drive source pin.
We are not against to that about connect 2/3 pins to one.
Dec 15, 2022
07:31 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 15, 2022
07:31 PM
Hi,
Do you have example of how to connect these two pins in schematic and layout?
Dec 15, 2022
07:58 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 15, 2022
07:58 PM