What is the process to re-program EVAL_SEN_SMART_ALARM?

Announcements

Measure CO2 When It Matters - Infineon’s XENSIV™ PAS CO2 now comes in SparkFun Red. Check it now!

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
GrCa_1363456
Level 6
Level 6
50 likes received Beta tester First comment on KBA

What documentation is available to support re-programming of the Battery Operated Glass Break Sensor kit, EVAL_SEN_SMART_ALARM @ https://www.infineon.com/cms/en/product/evaluation-boards/eval_sen_smart_alarm/ ?

Since it's PSoC 6 based, I'm guessing a Miniprog 4, CY8CKIT-005, can be used. Confirmation that the Miniprog can connect directly to the 10-pin X3, or if it should be connected to the 5-pin X2 along with any power, jumper or configuration settings required to program would be appreciated.

Are there different versions of firmware available to test different types of Glass Break or intrusion detection?

Greg

0 Likes
2 Replies
George_T
Moderator
Moderator
Moderator
50 likes received First question asked 250 replies posted

Hi @GrCa_1363456,

Since this is a new product, I am checking how we can support on this product?

Thanks and regards,

George

0 Likes
George_T
Moderator
Moderator
Moderator
50 likes received First question asked 250 replies posted

Hi @GrCa_1363456,

I am locking this thread as the discussion is moved to private channel.

Thanks and regards,

George

0 Likes