KIT_IM72D128V01_FLEX - pin configuration of flex boards

Announcements

Measure CO2 When It Matters - Infineon’s XENSIV™ PAS CO2 now comes in SparkFun Red. Check it now!

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
lock attach
Attachments are accessible only for community members.
hbit
Level 1
Level 1
First solution authored First like received First reply posted

I'm looking for the pin configuration of the flex boards. Especially the configuration of the five pads near the microphone itself. Attached is a picture to make it clear which pads.

Hope there is information about this available.

0 Likes
1 Solution
lock attach
Attachments are accessible only for community members.
hbit
Level 1
Level 1
First solution authored First like received First reply posted

Hi Honey,

thanks for the reply. It was not exactly what I was looking for. So at the end I checked the wires and I found the letters of the silk screen confirmed.

For everybody interested a picture attached.

Regards,

Helmut

View solution in original post

2 Replies
Honey_D
Moderator
Moderator
Moderator
5 comments on blog 50 likes received 250 replies posted

Hello @hbit ,

Please refer to the following documentation for pin configuration for the flex boards.

https://www.infineon.com/dgdl/Infineon-Microphoneflexevaluationkit-ProductBrief-v02_00-EN.pdf?fileId...

Best Regards,

Honey

0 Likes
lock attach
Attachments are accessible only for community members.
hbit
Level 1
Level 1
First solution authored First like received First reply posted

Hi Honey,

thanks for the reply. It was not exactly what I was looking for. So at the end I checked the wires and I found the letters of the silk screen confirmed.

For everybody interested a picture attached.

Regards,

Helmut