Legacy microcontrollers Forum Discussions

Hi! I very necessary need basic .hex file(led blink e.g.) for test RAM in Memtool for SAK-XC2765X. Could you send me this file, please?  Thanks!

hello

I would like to read code from Infineon MCU SAF-C164CI-8RM and write to a new one !

I am looking for suitable programmer.

could anyone advice me ?

Hi, all! I try to download CD files for KIT_XC2765X_SK  with Infinion site, but the link KIT_XC2765X_SK_CD_Download not valid. Can anybody send me .zip file or may be actual link , please?

I would like to know which manufacturer and model number of IC sockets your company recommends for the IC sockets in the black part of the image below (excluding the bottom board) when programming off-board rather than on-board.

下記画像の黒い部分のICソケット（下基板は除く）を貴社がどちらのメーカーの何という型番のICソケットをオンボードではなくオフボードで書込みする時に推奨しているのかが知りたいです。

Hello Team,

We received TLE9180D0-32QK board, We don't have any technical document for this .We need to know how to plash any documentation .

Note :We have UDE flashing tool from PLS .They mentioned XC2785C controller will support .

Been trying for awhile now to use S6E1C32 as a USB device. I've gotten far enough to where the device gets through enumeration and Windows will recognize it as a virtual COM port....sometimes.

Every time I press the reset button and run the same firmware load again, I get different results. Most of the time it cannot make it through enumeration and says that it failed to get the device descriptor. But other times it does and I can open up a terminal program and send data.

I borrowed a USB protocol analyzer, and it is also reporting a different errors every time I reset the device. It reports a lot of "Bad CRC", "Bad Signal" and "Invalid PID sequence" errors.

I then borrowed a high speed oscilloscope and looked directly at the Dp/Dn signals. I compared against a different microcontroller that also enumerates as a virtual COM port 100% reliably. I can't see an obvious difference. If anything, they look very similar and I would argue that the S6E1C32 signals might look a little bit better in terms of a cleaner signal. I don't have a lot of experience looking at USB signals on an oscope so I could be wrong.

Just reaching out for any ideas. "Bad CRC" and "Bad Signal" is not something that a software bug could induce? That's automatically generated in the part?

Hi, 

We received some parts (MPN: SAL-TC299TP-128F300N BC) on reels. The Infineon label says "SAMPLES." I wanted to ask if anyone can confirm that these are not custom parts? Do they still conform to the MFG specifications on the datasheet? Picture attached.