Sep 12, 2018
03:30 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 12, 2018
03:30 AM
I'm trying to program an MBR3102 using a Miniprog3 with EZ-Click. When I select the target device, the Miniprog3 is found, but my device is not. My connections are verified, with the exception of XRES, which does not exist on the MBR3102. Anyone have similar issues?
Solved! Go to Solution.
Labels
1 Solution
Sep 13, 2018
05:09 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 13, 2018
05:09 AM
The problem was, I did not have the 2.2nf capacitor connected to the CMOD pin. I added this and the chip was recognized. Thank you for your response!
2 Replies
Sep 12, 2018
08:25 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 12, 2018
08:25 PM
Try to give us a picture about the hardware connection, and share us the below screenshot.
Sep 13, 2018
05:09 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Sep 13, 2018
05:09 AM
The problem was, I did not have the 2.2nf capacitor connected to the CMOD pin. I added this and the chip was recognized. Thank you for your response!