- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
I purchased the FM4 pioneer kit and am attempting to follow the instructions detailed in page two of this document. I have installed everything and connected to the board in the serial port viewer tool. According to the instructions, I should be presented with a list of options to test the board. The problem is that I am instead presented with a blank screen. Whenever I keydown from the serial port viewer tool, LED2 on the board flashes twice. Otherwise there is no response and nothing is displayed in the command line.
I'm using a 2015 Macbook Pro so everything is being run through VirtualBox.
This is how it looks:
Any guidance is much appreciated.
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
please use another serial assistant terminal tools instead to test it again. such as SSCOM is recommended.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello
I have the same problem. Did you ever get a solution to this?
Thanks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
please use another serial assistant terminal tools instead to test it again. such as SSCOM is recommended.