Not applicable
May 02, 2013
05:10 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 02, 2013
05:10 AM
5 Replies
May 10, 2013
02:01 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 10, 2013
02:01 AM
Hi sfl, MPU is available in the XE166/XC2000, in the TriCore and the XMC family
Not applicable
May 27, 2013
05:07 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 27, 2013
05:07 PM
sfl wrote:
I am working with the XC164 family. Is there any mean to protect the code in flash from reading ? If not, is there any µC which can protect flash code ?
Go to the eg. XC164CM product page on the Infineon Homepage.
From "Documents" select XC164CM User's Manual System Units, Vol. 1 of 2 (xc164_um_v1.2_2006_03_sys.pdf).
Go to chapter "3.8 The On-Chip Program Flash Module" and read section "3.8.4 Protection and Security Features".
I guess that's what you were really looking for.
Not applicable
Nov 20, 2013
11:40 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Nov 20, 2013
11:40 PM
According the document :
"All protection feature control (install, disable, re-enable) is accomplished through
command sequences similar to the program/erase sequences (see Table 3-5)."
Today, program/erase sequence are done with Keil software. How can I do protection command ? Do I have to develop a specific software ?
Thanks for your answer.
"All protection feature control (install, disable, re-enable) is accomplished through
command sequences similar to the program/erase sequences (see Table 3-5)."
Today, program/erase sequence are done with Keil software. How can I do protection command ? Do I have to develop a specific software ?
Thanks for your answer.
Not applicable
Dec 09, 2013
12:14 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 09, 2013
12:14 AM
Hi sfl,
You can use Infineon Memtool to do the protection for your device.
The software can be downloaded from here.
You can use Infineon Memtool to do the protection for your device.
The software can be downloaded from here.
Not applicable
Dec 18, 2013
09:33 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 18, 2013
09:33 AM
I do believe you may have to ways to enable protection :
- The simple way is to enable protection with Memtool and a tool such as MiniWiggler.
- You can also enable/disable protection by software, but this would require a little bit more effort, and good knowledge of the internal flash driver.
- The simple way is to enable protection with Memtool and a tool such as MiniWiggler.
- You can also enable/disable protection by software, but this would require a little bit more effort, and good knowledge of the internal flash driver.