Jan 28, 2021
03:01 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 28, 2021
03:01 AM
To consider EMI noise of LITIX Basic+, is it ok to put one output capacitor to GND?
And how much capacitor should be selected in this case?
And how much capacitor should be selected in this case?
Solved! Go to Solution.
- Tags:
- IFX
1 Solution
Jan 28, 2021
07:03 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 28, 2021
07:03 AM
General recommendation is to place a capacitor on each OUTx-pin to GND.
A suitable ceramic capacitor of 4.7nF or 10nF should be placed close to the OUTx-pin.
See also the datasheet and application note on https://www.infineon.com/cms/en/product/power/lighting-ics/litix-automotive-led-driver-ic/litix-basi...
A suitable ceramic capacitor of 4.7nF or 10nF should be placed close to the OUTx-pin.
See also the datasheet and application note on https://www.infineon.com/cms/en/product/power/lighting-ics/litix-automotive-led-driver-ic/litix-basi...
1 Reply
Jan 28, 2021
07:03 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 28, 2021
07:03 AM
General recommendation is to place a capacitor on each OUTx-pin to GND.
A suitable ceramic capacitor of 4.7nF or 10nF should be placed close to the OUTx-pin.
See also the datasheet and application note on https://www.infineon.com/cms/en/product/power/lighting-ics/litix-automotive-led-driver-ic/litix-basi...
A suitable ceramic capacitor of 4.7nF or 10nF should be placed close to the OUTx-pin.
See also the datasheet and application note on https://www.infineon.com/cms/en/product/power/lighting-ics/litix-automotive-led-driver-ic/litix-basi...