Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

Knowledge Base Articles

Knowledge Base Articles

Recent documents

Sort by:
BinduPriya_G
Knowledge Base Articles
Version: **In the VADC module, one ADC converter has one dedicated Sample&Hold unit (no multiple S&H units). Therefore, the maximum number of analog ... Show More
BinduPriya_G
Knowledge Base Articles
Version: ** There is no specific crystal recommendation for AURIX™ MCUs. All typical crystals in the market in the specified frequency range should r... Show More
BinduPriya_G
Knowledge Base Articles
Version: ** If the Auto-discover compiler include paths is disabled, right-click on the folder to quickly add or remove a folder from the compiler inc... Show More
BinduPriya_G
Knowledge Base Articles
Version: **To create a library project in AURIX™ Development Studio, do the following: Click File > New > New AURIX™ Project from the AURIX™ Develo... Show More
BinduPriya_G
Knowledge Base Articles
Version: **The metadata of an object can be changed if the Life cycle state Object (LcsO) of the object is not in operational or termination state. I... Show More
MohammedA_41
Knowledge Base Articles
Version: ** In AURIX™ MCUs, program flash has 20 years of data retention time while the data flash has 10 years. Because the program flash is written... Show More
BinduPriya_G
Knowledge Base Articles
Version: **The tools available in the toolchain, enables the user to manually add flags by editing the Command line pattern under the Expert settings... Show More
BinduPriya_G
Knowledge Base Articles
Version: **In AURIX™ TC2xx, the maximum GTM (Generic Timer Module) clock frequency is 100 MHz; therefore, the highest resolution can be 10 ns. In AURI... Show More
BinduPriya_G
Knowledge Base Articles
Version: **The exposed die pad is used for cooling purposes and to allow better heat dissipation. It should be placed on the bottom side of the VQFN-... Show More
BinduPriya_G
Knowledge Base Articles
Version: *AThe net bandwidth, which can be achieved with HSSL, varies in a wide range from just a fraction up to ~82% of the maximal available bandwi... Show More
BinduPriya_G
Knowledge Base Articles
Version: **This KBA presents the results of performance measurements performed on different combinations of locations of source and store buffers usi... Show More
Neo_Lu
Knowledge Base Articles
In the magnetic sensor development tool, Infineon provides complete supporting software and source code based on Arduino platform; However, this arti... Show More
BinduPriya_G
Knowledge Base Articles
Version: **The primary monitor operation is based on tracking an analog-to-digital converter (ADC) to measure the supply voltages. It is clocked and ... Show More
BinduPriya_G
Knowledge Base Articles
Version: **On the AURIX™ TC2XX devices, the modulator and demodulator are used together; therefore, delta-sigma analog-to-digital converter (DSADC) d... Show More
BinduPriya_G
Knowledge Base Articles
Version: **The default switching frequency is 1.5 MHz during embedded voltage regulator (EVR) start up and you can configure this frequency between 0... Show More
BinduPriya_G
Knowledge Base Articles
Version: **For a parallel conversion, up to four Analog-to-Digital Converter (ADC) in a synchronization group can be exactly synchronized. In case of... Show More
BinduPriya_G
Knowledge Base Articles
Version: **There are two types of NC balls: NC: Not Connected. These pins are reserved for future extensions and shall not be connected externally. ... Show More
BinduPriya_G
Knowledge Base Articles
Version: **Input voltage high for S pad (VIHS) and input voltage low (VILS) for S pad are as follows: For AURIX™ TC2xx MCU series: VDDM = 5 V ... Show More
BinduPriya_G
Knowledge Base Articles
Version: **Boundary scan is possible on AURIX™ devices through the Joint Test Action Group (JTAG) or Device Access Port (DAP) interfaces. Boundary sc... Show More
BinduPriya_G
Knowledge Base Articles
Version: **In the AURIX™ family, the PFlash ECC mechanism implements a safety ECC methodology by default. If PFlash is erased, both the PFlash addres... Show More
Knowledge Base Information

Knowledge Base Articles

Knowledge Base Articles are product related resources written by our Apps Team Experts.
Top contributors