Showing results for 
Search instead for 
Did you mean: 

Knowledge Base Articles

Interfacing the SO pin to CY7B933

Not applicable

Interfacing the SO pin to CY7B933

Question: If the SO pin is pulled up (the SI input now becomes the INB- input), and at a later time this pull up is removed (after device interface configuration) does the SO become an output of the SI signal?



Yes, the SO signal has a sensory circuit that continuously reflects what it sees. In other words, after the interfaced device comes out of configuration (and the pull-up is removed), the sensory circuit connected to SO will change modes "on the fly". Consequently, SO will now assume the same logical level as SI, and INB will become a single-ended PECL serial data input.

Version history
Revision #:
1 of 1
Last update:
‎Jun 28, 2011 07:05 AM
Updated by: