Is it possible to get the CAD model of FZ3600R17HP4??

[Watanabi]

Is it possible to get the CAD model(Step file maybe?) of FZ3600R17HP4??

[Akhil_B]

Hi @Watanabi 

Thanks for posting on the Infineon Community page.

I have raised the internal request to get the step model. I will share it to you as soon as received.

Best Regards,

Akhil Kumar.

[Watanabi]

Hi 

Thank you very much!

Regards,

Ikkei Watanabe

[Akhil_B]

Hi @Watanabi 

Attached is the step file of the requested device.

Best Regards,

Akhil Kumar.

[Watanabi · Accepted solution]

Hi,

Thanks for the step file!!

It seems there are slight difference between the model and the drawing.

Could you request internally to check which one is wrong and if the model were wrong then is it possible to request them to modify it to the right dimension??

Best regards,

Ikkei Watanabe

[Akhil_B]

Dear @Watanabi 

Good Day!!

Sorry for the delayed response.

The dimensions mentioned in the data sheets 61.5mm and 13mm.

The dimensions mentioned in the STP - files (61.2mm and 12.75mm) correspond very exactly to the real dimensions!

These real dimensions are covered by the tolerances in data sheet.

Thanks & Best Regards,

Akhil Kumar.