s26kl512s flash model v1.6 : read status register command not work correctly

Tip / Sign in to post questions, reply, level up, and achieve exciting badges. Know more

cross mob
yodo_4825591
Level 3
Level 3
10 replies posted 10 sign-ins 5 replies posted

 


Hi,
 
When I use s26kl512s hyperflash model, i meet some problem about read status regiset command.
 
I send write buffer program first, as shown in the picture below:
 
[ write buffer program ]
yodo_4825591_1-1627527313449.png

 

Then I send write buffer program confirm command, as below:
 
yodo_4825591_2-1627527313450.png

 

 
I want to know when program done, so I send read status register CMD as below:
 
yodo_4825591_3-1627527313451.png

 

However, there are neither RWDS signal nor valid register value in the wave.
 
 
 
 
0 Likes
1 Solution
yodo_4825591
Level 3
Level 3
10 replies posted 10 sign-ins 5 replies posted

I have solve it.

 

My Flash controller's dummy cycle is too small.    

View solution in original post

0 Likes
2 Replies
yodo_4825591
Level 3
Level 3
10 replies posted 10 sign-ins 5 replies posted

I also have a question:  Is read latency setting  also applied to read status register command  or not?

yodo_4825591_0-1627527789482.png

thanks very much.

0 Likes
yodo_4825591
Level 3
Level 3
10 replies posted 10 sign-ins 5 replies posted

I have solve it.

 

My Flash controller's dummy cycle is too small.    

0 Likes