Jan 06, 2020
05:07 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 06, 2020
05:07 AM
Hi,
We are integrating microblaze (from xilinx) with hyperbus IP. And we are using AXI4.
We tried to write control registers like MCR0, GPOR, Loopback registers of HyperBus IP. But all the register values when readback are showing default values. What would be the reason for this?
Solved! Go to Solution.
1 Solution
Jan 07, 2020
10:42 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 07, 2020
10:42 AM
Hello Vishal,
Please refer to outlook email for Cypress response.
Thank you
Regards,
Bushra
2 Replies
Jan 06, 2020
04:08 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 06, 2020
04:08 PM
Hello Vishal,
Thank you for contacting Cypress Community Forum. We are working on your issue sent via outlook. Please bear with us.
Have a wonderful day
Regards,
Bushra
Jan 07, 2020
10:42 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Jan 07, 2020
10:42 AM
Hello Vishal,
Please refer to outlook email for Cypress response.
Thank you
Regards,
Bushra