Dear Team,
Good morning.
We are using your 1EDI60N12AF in our simulation.
I would like to confirm few things below before explaining the issue.
We have used/given,
1.VCC1=5V supply(DC)
2.INP=3.3V ADC having 10KHz switching frequency and 60% duty cycle
3.INN-Grounded
4.VCC2=15V Supply(DC)
5.Gnd2=- 5V(Negative 5V) DC supply given in order to completely turn of switch(IGBT/mosfet)
Issue in simulation:
The given model is only working for VCC1=3.3V
If we give 5V in VCC1 then in output we don't get gate pulse instead we get -5V DC(steady DC Value).
As per datasheet we can give up to 15V to VCC1 pin.
Kindly provide us support and solution as early as possible.
Thank you,
Girish Kantharaju
