Dec 02, 2014
02:50 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 02, 2014
02:50 AM
Good day,
Each time then I adding new Application (Say DACWG002) to existing project, or change
"Signal Connection" parameter, H/W Connectivity view refreshing each time.
And from nice picture transforms in some mess...
Is it a way exist disable this functionality, keeping in mind that separate knob "Refres and .." (Two yellow arrows) exist??
Best regards,
Konstantin
Each time then I adding new Application (Say DACWG002) to existing project, or change
"Signal Connection" parameter, H/W Connectivity view refreshing each time.
And from nice picture transforms in some mess...
Is it a way exist disable this functionality, keeping in mind that separate knob "Refres and .." (Two yellow arrows) exist??
Best regards,
Konstantin
1 Reply
Not applicable
Dec 02, 2014
07:02 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Dec 02, 2014
07:02 PM
Hi Konstantin,
I'm afraid that there is no way to get rid of this at this time being.
However, we have already submitted a change request (eTicket 37847567) which will be implemented in the next major DAVE release.
Best regards,
Sophia
I'm afraid that there is no way to get rid of this at this time being.
However, we have already submitted a change request (eTicket 37847567) which will be implemented in the next major DAVE release.
Best regards,
Sophia