Not applicable
May 13, 2016
09:43 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 13, 2016
09:43 AM
Hello,
I have a Dave3 project using XMC4500 100x1024. I generated the Keil project from it and the debugger works fine in Keil.
But switching back to Dave, i get this error exception when starting to Debug.
Even if i removed the RTE folder which is needed by Keil, i get the same error.
Do you know what could be the root causes of that?
I have a Dave3 project using XMC4500 100x1024. I generated the Keil project from it and the debugger works fine in Keil.
But switching back to Dave, i get this error exception when starting to Debug.
Even if i removed the RTE folder which is needed by Keil, i get the same error.
Do you know what could be the root causes of that?
- Tags:
- IFX
1 Reply
Not applicable
May 17, 2016
12:53 AM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
May 17, 2016
12:53 AM
HI,
Was your original DAVE3 project able to be debugged?
Also, are you using the generated .gpdsc in DAVE to run your project in Keil?
Regards,
Daryl
Was your original DAVE3 project able to be debugged?
Also, are you using the generated .gpdsc in DAVE to run your project in Keil?
Regards,
Daryl