- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello,
I'm trying to build a controller to program CY22393 with IIC interface, and there are two problems I have been struggling with. Hopes you can help.
1. when serial programming the device and Current Address Read Operation is chosen, after the device transmits 8-bits word, “The master device(in this case, the controller) DOSE NOT acknowledge the transfer, but generates a STOP condition, which causes the CY22393 to stop transmission”, but the figure 3 in the datasheet shows that "the device issue an ACK then 8-bits blank then master ACK and then a STOP condition". So which one is right?
2. when programming the Clk*_FS, if ClkA_FS[2:0]==001, the clka source is reserved. I'm wondering if I do set ClkA_FS==001, then what would happen?
Thanks!
Still a toddlers, sincerely.
- Labels:
-
Programmable Clocks
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hello Paulsons,
Can you kindly let us know your e-mail id? I am Sampath Selvaraj, Apps Engr in Cypress Technical Support. I would like to create a Technical Support Case for your issues, and assist you in solving them. If you can let us know your phone number also, it would be a great plus. Looking forward to assisting you.
Thanks and regards,
Sampath Selvaraj
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
Hi Sampath,
Thanks for your attention! you could contacted me via ywl2927@mail.ustc.edu.cn.
Best regards,
W.L.Young