1、您好 ，现在计划 使用 EVAL_PASCO2_MINIBOARD ，Infineon官网有 原理图SCH等

2、但是没有发现 EVAL_PASCO2_MINIBOARD PCB layout的Ad文件 和 EVAL_PASCO2_SENSOR2GO的 PCB layout文件和软件程序；我想layout一个PCB，EVAL_PASCO2_MINIBOARD  直接对插就可以了，现在不知道MINI BOARD 的插针具体数据

3、UM_XENSIV_PAS_CO2_miniboard-UserManual-v01_01-EN  这个是PSOC6+EVAL_PASCO2_MINIBOARD  ,请问程序在哪儿下载呀 ？

TEL：17317187679

Thanks

Dear Community,

I am wondering if it's possible to significantly improve the response time of the CO2 sensor by for example removing the membrane covering the sensor casing (white dot in image below).

What is the purpose of this membrane? Protect from dirt and moisture? If the sensor would be used in an otherwise "safe", i.e. dry and clean environment, would one need the membrane? I am aware that the warranty would be void when using the sensor in this way, but we need a much faster response than what the sensor can do with the current setup and this sensors speed is certainly not limited by the measurement principle. 

I hope someone can help!

Thanks,

Johannes